How to change your garage remote battery

Farpointe Remotes

Our two button Farpointe remotes are the best in class remote for reliability and range.

Changing the battery in Farpointe remotes.

These transmitters use a replaceable CR2032, 3.3V, lithium battery³, enclosed in a tamper-proof battery compartment. The battery should be replaced when a button press does not result in a flash of the LED, reliable read range, and/or an output from the Receiver.

To replace the battery, follow the directions below:

1. Using a coin, place it in the gap (2-piece unit) near the key ring holder and twist to pop the transmitter open.

2. Remove the old battery.

3. Insert the new CR2032, 3.3V, lithium battery. Be sure the plus (+) side of the battery is facing up (visible when installed).

4. Snap both pieces together.

image of black Ikey2 remote with two buttons

iKey2 Remotes

iKey2 remotes are found across some Canberra sites.

Changing the battery in your iKEY2 garage remote is straightforward and requires minimal equipment.

What you’ll need:

  1. a small Philips head screwdriver

  2. a new CR2032 battery

These can be purchased from CXI or most outlets that sell batteries such as Woolworths, Kmart, Bunnings etc.

To change the battery:

  1. Use your small screwdriver to remove the one or two screws located at the top/bottom on the back of the remote.

  2. Remove the back cover gently

  3. Slide out the old battery out with your fingernail or the tip of the screwdriver from it’s metal seat.

  4. Dispose of the old battery safely and immediately (keep it away from children!).

  5. Insert the new battery with the flat side facing up.

  6. Align all the buttons with the rubber insert sections, snap the covers back together, and reinsert the screws.

Previous
Previous

Setup Rust Desk remote desktop

Next
Next

Integriti / GateKeeper - User Management